Thank you for choosing myHummy®. Safety is the most important thing for us. Please read this manual carefully before using the product.
THE PURCHASED SET INCLUDES:
- teddy bear
- light, sound and vibration device
- manual
CHILD SAFETY
Noise toys should not be right next to a child’s ear. We recommend keeping the humming device at an appropriate distance from the baby’s head.
GENERAL INFORMATION
myHummy® has been designed to help young children calm down and fall asleep. The electronic sound device emits 3 types of noise and 3 melodies. In addition, the device simulates the vibration of a heartbeat and has a built-in light with 2 warm colours.
BEFORE THE FIRST AND EACH SUBSEQUENT USE
Check exactly individual parts of the product before each use to detect any defects. If a product defect is detected, immediately cessavities and contact the manufacturer immediately. The product packaging is not part of the product and is not a toy. Before handing the child toy, remove the entire packaging.
INSTALLATION OF THE DEVICE IN THE PLUSH
The playback device should only be turned on when it is in the pocket of the plush. To insert the device, unclute Velcro and place the device in your pocket. Velcro must always be closed so that the playback device does not get into a child’s hands.
DEVICE CONTROL
The ON/OFF main switch is located on the side of the module. Slide it once to “ON” to turn on the system and to “OFF” to turn off the system.
Controlling the operation of the sound device takes place manually. You can control the sound and vibration with the left button with the speaker icon and the light with the right button with the light bulb icon. You can use sound or light mode independently.
TURNING ON AND OFF THE SOUND DEVICE
When the main switch is in “ON” postion.
- To turn the sound device on, press the left button with the speaker icon
(sound will be played for 30 minutes). - To turn the sound device off, press the button and sound will stop playing.
CHANGE OF SOUND:
List of sounds in playback order:
- Pink noise
- Heart beat
- Sea side
- Brille Brille Lullaby
- Brahmn lullaby
- Minuet F Major K2
- Vibration with heartbeat rhythm
To change the sound, press the button quickly 2 time.
ADJUSTING THE VOLUME
Your myHummy has couple volume levels. To change the volume, press
and hold the left button with the speaker icon until the sound reaches
the desired volume and release the it. Repeat to change the volume up
and down. The sound device will store your previously selected sound and
volume level when it automatically restarts or is manually turned back on.
SLEEP SENSOR (ONLY SOUND MODE)
To enable the Sleep Sensor ON, start playback, select the track you want
to play, than press and hold both the right and left button simultaneously
for 3 seconds until the light will flash blue color 3 times. The Device will
start playing after first louder noise and will play for 30 minutes and start
to fade out. After fading out, the device will enter stand-by mode with the
Sleep Sensor mode on. If the sound gets louder again, the same sound will
gently fade in until it reaches the previous volume level. The sound will
play for another 30 minutes. This process will continue for the next 12
hours or until switched off by user.
Pressing the the left button with the speaker icon will disable the Sleep
Sensor.
LIGHT
When the main switch is in “ON” postion.
- To turn the light on: Press the right button with the light bulb icon.
- To turn the light off: Press again the right button with the light bulb
icon.
ADJUST COLOUR
The night light have to colors – worm-red and white. Every time you turn
it ON the light have a different color. If You turn it on and it has color that
You don’t want just turn it OFF and ON again.
BATTERY CHARGING
Important: Before charging, remove the light and sound module from the
cuddly toy.
If the module needs to be charged it will show a red light that flashes
slowly. While charging, the module will show a steady red light. It takes
approx. 2 hours to charge a completely empty battery. When the battery
is fully charged, the module will show a green light.
Low battery power can affect the strength of the light and volume of
the module. If the sound quality or volume of the sound decreases
significantly, use the supplied USB cable (USB-C to USB-A) to connect
the module.
Plug the USB-C plug into the module and connect the USB-A to a charger.
Then plug the charger into a power outlet. Please note: charger is not
included.
REMEMBER!
- The module may only be charged under adult supervision.
- We recommend that you charge the module out of the reach of children.
- Do not leave the module unattended while charging.
- If you see any signs of possible damage, stop charging immediately.
BATTERY
The module contains a lithium battery. This battery has the following
specifications:
- Rated Voltage: 3.7V
- Battery size: 902535
- Estimated cell capacity: 800 mA
- Reverse polarity protection
The device may be charged with a USB-C port. Charger not included.
Charger specifications reference:
- Supply Voltage: DC5V
- Nominal charging current: 1 A
- Source maximum current capacity: 1.2 A
- Protection against overcharge > 1.2 A
- Overheat protection: 60D
- Short circuit protectio
WASHING INSTRUCTIONS
All myHummy products are made from high quality, machine washable
materials.
ATTENTION! Always ensure you have removed the sound device from
the pocket before washing! If the sound device has come into contact
with water, it must not be used and should be discarded according to the
disposal regulations for electronic goods.
myHummy products can be washed at max. 40°C/ 104°F and the travel
pouch up to 60°C/ 140°F. To maintain the original shape of the product,
slightly stretch the material after washing. Make sure the pocket is
completely dry before inserting the sound device.
- Do not tumble dry
- Do not iron
- Do not dry clean
WARNING! Playing devices is not a toy!
- can only be used after safe storage inside the plush
- keep the device out of the child’s reach
- exactly check if the mechanism pocket is well closed before you
- give your child toy
IMPORTANT: Always remember your child’s safety!
GUARANTEE
The product is covered by a 12-month manufacturer’s warranty. The
limitation period for the investigation of warranty claims is essentially 2
years. The basis for the warranty is the original proof of purchase. The
product is not guaranteed in case of improper use or after unauthorised
repairs. Operating instructions should be seen as a source of later
information.
ENVIRONMENTAL PROTECTION
This equipment is marked with the selective sorting symbol relating to the
disposal of electrical and electronic equipment. The product should be handed over to a selective collection system conforming to the Guideline 2002/96/ EC (WEEE), so that it can be either recycled or dismantled in order to reduce its impact on the environment. Electronic products not undergoing selective sorting are potentially dangerous to the environment. For more information about recycling, please contact your local authorities. This toy contains batteries that are non-replaceable
SIMPLIFIED EU-COMPLIANCE DECLARATION
Szumisie Sp. z o. o. Hereby declares that a toy and a sound-making device complies with the toy directive 2009/48 / EC, from art. 1 of Directive 2014/35 / EU and from art. 6 of the directive 2014/30 / EU. The full text of the EU conformity declaration is available at the following web address: https://myhummy.com/declaration
Szumisie Sp. z o.o. – Jamno 73 B 99-400 Łowicz Poland
– V1.00 –